The tensile strength after light treatment, the natural light shines on the bag webbing through the window, causing aging and reducing its strength. According to the working conditions, a lighting equipment is designed, which is equipped with representative strong light and is exposed to the light for a specified time. After lighting, pp webbing needs to be subjected to standard temperature and humidity treatment, and then to tensile test to obtain the tensile strength after lighting treatment. After soaking, the tensile strength of the safety belt installed in the car will absorb the moisture in the air, and sometimes it will be soaked by some liquid, so the immersion test is required. At room temperature, fully immerse in distilled water with a small amount of wetting agent for a specified time, and then take out the soaked pp webbing from the water to complete the tensile test within 10 minutes. The tensile strength of soaked pp webbing was obtained.
In the 1970s, due to the promotion of continuous ribbon dyeing and ironing machine, Anshan Woven belt Manufacturer From the traditional process of dyeing before weaving to the continuous process of weaving before dyeing, weaving before bleaching, ironing after treatment, the ribbon technology has entered the ranks of mechanized mass production. In the early 1980s, the industry introduced high-speed shuttleless loom, ironing machine, wrapping machine, warping machine, etc. from Switzerland, Italy and the Federal Republic of Germany, and the ribbon technology entered a new stage of development. The progress of webbing technology has brought about the upgrading of products. In 1980, customized Woven belt Manufacturer The rubber ingot belt has the characteristics of soft, light, thin, firm, small elongation, small impact force, short and flat joints.
Indirect plate making method: the indirect film is first exposed, hardened with 1.2% H2O2, developed with warm water, and dried to make a strippable graphic negative. During plate making, the adhesive film surface of the graphic negative is closely attached to the stretched screen, the adhesive film is tightly attached to the wet screen by extrusion, the film base is removed, and the screen is dried by wind. Process flow: 1. Stretched wire mesh - degreasing - drying. 2 Indirect film - exposure - hardening - development - fitting - drying - revision - blocking. 3 Straight mixed plate making method: first, paste the photosensitive adhesive layer on the screen frame with water, alcohol or photosensitive adhesive, dry it with hot air, remove the substrate of the photosensitive film, and then print the plate. After developing, the screen plate is made.
How much does a yard weigh? This is for accurate quotation. If you calculate the weight of one yard, you can know how much material is used for this yard of webbing. Is it single-sided or double-sided? Some are divided into single side and double side, so this should also be asked clearly. There are pictures for reference. This is to give us a visual judgment of what is, and give us a more accurate factor of quotation. How many are there? This is a matter of deciding whether to give customers a discount. If there is a large quantity, there must be a discount. Combine factors such as the wages of the factory, the master and the workers.
