Customized Shuttleless webbing manufactor The basic process flow of knitting is: bleaching and dyeing - weft rolling - weaving - off machine cutting - packaging. Since 1960, many technical innovations have been carried out on the knitting machine, mainly including the enlargement of peach plate diameter, the installation of an automatic stop device for breaking rubber bands, and the replacement of iron ingots with nylon ingots. The improvement of these equipment has increased the speed to 160~190 rpm and doubled the stand rate, Anshan Shuttleless webbing manufactor The product quality has been greatly improved. In 1980, SD-81A and B rubber ingot belts were developed, which are soft, light, thin, firm, with small elongation, small impact force, short and flat joints. At the beginning of 1990, the trial production of car seat belts for Santana cars was successful. After more than two years of research and trial production, the product quality reached QC49-92 and TL-VW470 standards.
At present, more than 90% of the market is made of cotton polyester thread or polyester cotton thread, but there are few pure cotton threads in the market, and the price is surprisingly high! Polyester cotton yarn just neutralizes the advantages of pure cotton and polyester, depending on the composition of polyester in cotton. Generally, the yarn of cotton ribbon is made by adding a small amount of polyester into cotton, so that it can have the advantages of pure cotton and polyester cotton. It is easy to wash, heat resistant, alkali resistant, moisturizing, sanitary, wear-resistant, not shrink, not easy to wrinkle, not easy to deform, not easy to stick wool, and so on! The key is that the proportion of cotton and polyester is appropriate! The identification method of pure cotton webbing and polyester cotton webbing is simply to take the cut thread and burn it. If there is any hard block, it is polyester cotton yarn containing polyester, and if it is completely reduced to ashes, it is authentic pure cotton.
Width detection: the tolerance of webbing with width of 1 "and above shall not exceed ± 0.25 points; The tolerance of webbing with width of 25MM and above shall not exceed ± 0.5MM; The standard tolerance of webbing width of 1 "and less than 25MM shall not exceed ± 0.25MM; Note: The flat end and herringbone edging webbing must be of sufficient size, but not more than 0.25 points. Thickness inspection: the tolerance shall not exceed ± 0.1MM; Color difference test: there is no yin and yang color on the belt surface by naked eye, and the needle edge and cloth edge cannot be exchanged for the color and texture (the needle edge of each woven belt must be of one color). Singeing and labeling: Each bag ribbon must be singed thoroughly, but cannot be burnt. The quality inspector shall inspect the packaging label to be consistent with the actual goods (specification, color, quantity), and seal it for warehousing. If errors and omissions are found, the relevant processes shall be traced in time, and the relevant personnel shall be held accountable according to the seriousness of the case.
It is precisely because of this performance that silk fabrics are more suitable for direct contact with human skin. Therefore, we can directly wrap a unique garment with silk scarves in the hot summer, which is not only beautiful but also comfortable. Silk not only has good heat dissipation performance, but also has good warmth retention. Its thermal insulation is proud of its porous fiber structure. There are many tiny fibers in a silk fiber, and these tiny fibers are composed of even smaller fibers. Therefore, more than 38% of the seemingly solid silk is actually hollow, and there is a large amount of air in these gaps, which prevents the heat emission and makes the silk have good warmth retention.
