The printing is in the passenger compartment to enhance the matching and coordination with the color in the cabin. The binding ribbon printing will be dyed into various colors. People always hope that the color dyed will not fade within the specified time. Therefore, the belt has a specific color fastness test. The wrapped webbing belt is exposed to light, and like other substances, it will fade. The wrapped webbing has this characteristic, which is called light color fastness. In this test, the webbing is placed under representative strong light and exposed to the specified time. Then compare the bag webbing with the standard color card to evaluate a fading grade.
The tensile strength after light treatment, the natural light shines on the bag webbing through the window, causing aging and reducing its strength. According to the working conditions, a lighting equipment is designed, which is equipped with representative strong light and is exposed to the light for a specified time. After lighting, pp webbing needs to be subjected to standard temperature and humidity treatment, and then to tensile test to obtain the tensile strength after lighting treatment. After soaking, the tensile strength of the safety belt installed in the car will absorb the moisture in the air, and sometimes it will be soaked by some liquid, so the immersion test is required. At room temperature, fully immerse in distilled water with a small amount of wetting agent for a specified time, and then take out the soaked pp webbing from the water to complete the tensile test within 10 minutes. The tensile strength of soaked pp webbing was obtained.
Unused products from knitting production line are called Fuzhou Brocade ribbon The strength, width, thickness, elongation and stiffness described above are all Fuzhou special Brocade ribbon These measured data are called Brocade ribbon Data. The safety belt installed in the car should be worn by the passengers after they get on the car. The use process is an aging process, and its strength will decline. In order to ensure that the safety belt can effectively protect the passengers before the vehicle is scrapped, the strength of the webbing shall be measured after simulating the working conditions. This strength is called the strength after the environmental test special Brocade ribbon strength. After the environmental test, the strength includes light treatment, low temperature treatment, high temperature treatment, immersion test and wear treatment.
In the 1970s, due to the promotion of continuous ribbon dyeing and ironing machine, the processing of ribbon has developed from the traditional process of dyeing before weaving to weaving before dyeing, weaving before bleaching, ironing after processing, and the ribbon technology has entered the ranks of mechanized mass production. In the early 1980s, the industry introduced high-speed shuttleless loom, ironing machine, wrapping machine, warping machine, etc. from Switzerland, Italy and the Federal Republic of Germany, and the ribbon technology entered a new stage of development. The progress of webbing technology has brought about the upgrading of products. In 1980, the rubber ingot belt was developed, which has the characteristics of soft, light, thin, firm, small elongation, small impact force, short and flat joints.
Xiao Bian always believes that any backpack and webbing factory needs to constantly promote safety in production. In addition to conventional production safety and personal safety of employees, fire prevention should be an important part of this safety. The industry is a flammable industry, because a large number of various yarns and finished webbing products stacked in its workshops are flammable, its safety is directly related to human life safety. Therefore, it is important for enterprises to prevent fire. In the past two years, there have been fires in many ribbon factories across the country, which has caused huge property losses to enterprises. The frequent occurrence of fires in the ribbon industry has also sounded a safety alarm for us. The safety of the company is also closely related to the employees. As a member of the company, fire prevention should start from self. Do not smoke in the factory. If you want to smoke, please go to the specified smoking area. Don't throw cigarette butts everywhere, let yourself be a part, and protect our safety together.
