The steps of printing. Many friends don't know how to do it. In fact, there are two methods. So the master of PP ribbon factory will let you know. Direct plate making method: the method of direct plate making is to first place the photosensitive film of the wrist plate base coated with photosensitive material face up on the working table, place the stretched wrist net frame flat on the film base, then put photosensitive paste in the screen frame and apply pressure coating with a soft scraper, remove the plastic film base after drying and filling, and attach the photosensitive film wrist screen for printing. After developing After drying, screen printing is made. Process flow: stretched screen - degreasing - drying - peeling substrate - exposure - development - drying - revision - blocking
The basic process flow of knitting is: bleaching and dyeing - weft rolling - weaving - off machine cutting - packaging. Since 1960, many technical innovations have been carried out on the knitting machine, mainly including the enlargement of peach plate diameter, the installation of an automatic stop device for breaking rubber bands, and the replacement of iron ingots with nylon ingots. The improvement of these equipment has increased the vehicle speed to 160~190 rpm, doubled the stand rate and greatly improved the product quality. In 1980, SD-81A and B rubber ingot belts were developed, which are soft, light, thin, firm, with small elongation, small impact force, short and flat joints. At the beginning of 1990, the trial production of car seat belts for Santana cars was successful. After more than two years of research and trial production, the product quality reached QC49-92 and TL-VW470 standards.
Indirect plate making method: the indirect film is first exposed, hardened with 1.2% H2O2, developed with warm water, and dried to make a strippable graphic negative. During plate making, the adhesive film surface of the graphic negative is closely attached to the stretched screen, the adhesive film is tightly attached to the wet screen by extrusion, the film base is removed, and the screen is dried by wind. Process flow: 1. Stretched wire mesh - degreasing - drying. 2 Indirect film - exposure - hardening - development - fitting - drying - revision - blocking. 3 Straight mixed plate making method: first, paste the photosensitive adhesive layer on the screen frame with water, alcohol or photosensitive adhesive, dry it with hot air, remove the substrate of the photosensitive film, and then print the plate. After developing, the screen plate is made.
It may be due to the use of too much thinner, especially the poor compatibility of thinner and ink, which causes color bleeding during PP textile printing. It may be that there is color seeping on the edge of the printed image and text, which is a common phenomenon, so don't worry too much. It can be solved by ordinary methods. It may be caused by the selection of dyes in the ink, or it can be said that it is caused by the improper matching of pigments. We can deal with the problems in this link according to the situation, and pay attention to the details in this link.
Webbing manufactor Here are some examples of the production process of radio lanyard, toy lanyard, flashlight lanyard and camera lanyard. 1. Wholesale of webbing: nylon, pp, polyester and high elastic cotton are generally used to make lanyards, and the general specifications are 4mm, 5mm, 6mm, 7mm, 8mm, 10mm, 12mm, 16mm, 20mm and 25mm wide. 2. Accessories: universal Xiamen customized Webbing The accessories include metal clasps, certificate clips, etc., while the plastic ones include aircraft clasps, plug-in clasps, safety clasps, etc. 3. Assembly: first print, cut according to the specified size, add string, plastic buckle, glue or press metal sheet, and then package. After inspection, a lanyard can be shipped in this way.
