Flat screen printing. The printing mould is a polyester or nylon screen (pattern) fixed on a square frame with hollow patterns. The pattern on the pattern plate can pass through the color paste, and the mesh without pattern can be sealed with a polymer film. When printing, the pattern is pressed against the fabric, and the color paste is placed on the pattern. The scraper is used to repeatedly scrape and press the color paste to reach the fabric surface through the pattern. Flat screen printing has low production efficiency, but wide adaptability and flexible application, suitable for small batch and multi variety production. Water slurry printing of bag webbing.
Anshan Aramid tape Causes of bleeding. Some customers will customize the printing Customized Aramid tape However, the color bleeding sometimes occurs when the PP fabric manufacturer prints the PP ribbon, so the manufacturer should pay attention to the reasons when printing. Only by understanding these reasons can we reduce the occurrence of various conditions in the future use Aramid tape wholesale What causes color bleeding when printing? There is dirt on the surface of the machine during printing. Cleaning up during production can reduce these problems.
The tensile strength after light treatment, the natural light shines on the bag webbing through the window, causing aging and reducing its strength. According to the working conditions, a lighting equipment is designed, which is equipped with representative strong light and is exposed to the light for a specified time. After lighting, pp webbing needs to be subjected to standard temperature and humidity treatment, and then to tensile test to obtain the tensile strength after lighting treatment. After soaking, the tensile strength of the safety belt installed in the car will absorb the moisture in the air, and sometimes it will be soaked by some liquid, so the immersion test is required. At room temperature, fully immerse in distilled water with a small amount of wetting agent for a specified time, and then take out the soaked pp webbing from the water to complete the tensile test within 10 minutes. The tensile strength of soaked pp webbing was obtained.
What does Dandong Guangwei Textile Weaving Group explain? Generally speaking, chemical fiber is added to cotton, a kind of polyester material. The invention of polyester and cotton has promoted the great progress of human textile, and it also has many advantages. Polyester cotton increases the tenacity of pure cotton yarn, which is not easy to break, and has elasticity! Some advantages of pure cotton, such as hygroscopicity and moisture retention, are mainly aimed at garment accessories. Some are not important to the fabric, and some are even shortcomings; The advantages of polyester are exactly what the ribbon yarn needs.
Width detection: the tolerance of webbing with width of 1 "and above shall not exceed ± 0.25 points; The tolerance of webbing with width of 25MM and above shall not exceed ± 0.5MM; The standard tolerance of webbing width of 1 "and less than 25MM shall not exceed ± 0.25MM; Note: The flat end and herringbone edging webbing must be of sufficient size, but not more than 0.25 points. Thickness inspection: the tolerance shall not exceed ± 0.1MM; Color difference test: there is no yin and yang color on the belt surface by naked eye, and the needle edge and cloth edge cannot be exchanged for the color and texture (the needle edge of each woven belt must be of one color). Singeing and labeling: Each bag ribbon must be singed thoroughly, but cannot be burnt. The quality inspector shall inspect the packaging label to be consistent with the actual goods (specification, color, quantity), and seal it for warehousing. If errors and omissions are found, the relevant processes shall be traced in time, and the relevant personnel shall be held accountable according to the seriousness of the case.
