Under normal use, the general use time is about three years. After three years, because of natural wear, part of the pp webbing will be corroded and broken. But this is under normal use. If it is not used frequently, similar situations will not occur. The reason why most of them cannot be used for such a long time is because they are lost in advance rather than because of other external damage. Therefore, the advice of Xiaobian is not to worry too much about the service life of the PP webbing, but to pay attention to how to protect yourself from loss and trouble.
Flat screen printing. The printing mould is a polyester or nylon screen (pattern) fixed on a square frame with hollow patterns. The pattern on the pattern plate can pass through the color paste, and the mesh without pattern can be sealed with a polymer film. When printing, the pattern is pressed against the fabric, and the color paste is placed on the pattern. The scraper is used to repeatedly scrape and press the color paste to reach the fabric surface through the pattern. Flat screen printing has low production efficiency, but wide adaptability and flexible application, suitable for small batch and multi variety production. Water slurry printing of bag webbing.
It may be due to the use of too much thinner, especially the poor compatibility between thinner and ink, which causes color bleeding during PP textile printing. It may be that there is color seeping on the edge of the printed image and text, which is a common phenomenon, so don't worry too much. It can be solved by ordinary methods. It may be caused by the selection of dyes in the ink, or it can be said that it is caused by the improper matching of pigments. We can deal with the problems in this link according to the situation, and pay attention to the details in this link.
computer Benxi Aramid tape Manufacturer The drawing process of. Many friends are interested in computers Customized Aramid tape Manufacturer I'm particularly interested. Xiao Bian has briefly introduced the textile technology of the computer jacquard belt before, but many people are still interested in how to draw the computer jacquard belt. Today, I will introduce its drawing method according to the drawing process of the ribbon. Single color change: change the color of the left or right mouse button in the picture according to the position within the parameter range, and change the color of a connected color block within the parameter range. The color changed depends on whether the left or right mouse button is pressed. Select a rectangular range: click two points in the editing area to form a rectangular range with these two points as the opposite corners, so that you can clear, cut, copy, and organize this rectangular range. Clear out of parameter drawings: Clear the drawings outside the set range of longitude and latitude.
The printing is in the passenger compartment to enhance the matching and coordination with the color in the cabin. The binding ribbon printing will be dyed into various colors. People always hope that the color dyed will not fade within the specified time. Therefore, the belt has a specific color fastness test. The wrapped webbing belt is exposed to light, and like other substances, it will fade. The wrapped webbing has this characteristic, which is called light color fastness. In this test, the webbing is placed under representative strong light and exposed to the specified time. Then compare the bag webbing with the standard color card to evaluate a fading grade.
The moisture in the air may cause spots in the car. When this kind of webbing contacts the clothes of passengers, the spots and colors on the luggage webbing will also be transferred to the clothes. Therefore, it should have anti spot fading characteristics, which is also called spot color fastness. The spot color fastness test includes multi fiber test and filter paper test. The multi fiber test is to clamp a sample of tissue belt between two layers of colored cloth. Immerse the mixed colored cloth into the vessel with distilled water and completely wet it. Then squeeze the water out of the extruder, and then clamp these colored cloth wrapped with selvedge webbing into the plexiglass sheet, put it into the sample holder, and lock the sample holder. This rack is placed in a high and low temperature box at a certain temperature, and after reaching the specified time. Take out the sample and hang the colored cloth.
